Thermo-6 Interfaces

Data is exchanged between the machine control and the Thermo-6 temperature control unit. To control system the temperature control system unit via an external controller, access is required via the appropriate interface, click here...

Ethernet

The interface provides an OPC UA server. A client is required for communication. This can either be integrated in PC software (e.g. OPC UA Browser) or in a machine control system. Data is exchanged either directly between the machine control and the Thermo-6 temperature control unit or via the Interface Server Gate-6.

• Ethernet interface OPC UA (EUROMAP 82.1 Release 1.01 / OPC 40082-1)
• Switch with 2 sockets RJ-45

NOTE!

Shielded Category 5 or higher cable must be used for Ethernet connections. These cable are available from standard retailers.

USB

Connection for software updates and for transferring unit data.

• USB-A

NOTE!

A USB type A disk with a single partition and the FAT, FAT32, exFAT, or ext2/3/4 file systems is supported. These USB data carriers are available at standard retailers.

HB CAN intern

HB-Therm CAN data interface for connection flowmeters Flow-5 or Power supply powering the Gate-6 interface server.

• 1 15-pin Sub-D socket
• Interface cables can be found in the accessories catalogue
  • https://hb.click/D8064-DE

Cable pin-assignment

Alarm and external control (ZB)

The temperature control unit can be connected to the machine control system and controlled via potential-free contacts.

• 1 Harting Han 7D plug
• cable for alarm contact and external control can be found in the accessories catalogue
  • https://hb.click/D8064-DE

Functions of the potential-free changeover contact:

• Reading the alarm status
• Switch on and switch off
• Switch between two setpoints (Set temperature 1 and 2)

Cable pin-assignment